testWaitScopePerformEdgeAnalysis

Valid for: CANoe DE • CANoe4SW DE

Function Syntax

long testWaitScopePerformEdgeAnalysis(message frame, ScopeAnalyseRange analyseRange, dword flags, long thresholdStart long thresholdEnd, ScopeEdgeAnalyseResult parameter[], dword parameterCount, ScopeAnalyseHandle handle) //Form 1
long testWaitScopePerformEdgeAnalysis(linFrame frame, ScopeAnalyseRange analyseRange, dword flags, long thresholdStart long thresholdEnd, ScopeEdgeAnalyseResult parameter[], dword parameterCount, ScopeAnalyseHandle handle) //Form 2
long testWaitScopePerformEdgeAnalysis(frFrame frame, ScopeAnalyseRange analyseRange, dword flags, long thresholdStart long thresholdEnd, ScopeEdgeAnalyseResult parameter[], dword parameterCount, ScopeAnalyseHandle handle) //Form 3
long testWaitScopePerformEdgeAnalysis(char nodeName[], ScopeAnalyseRange analyseRange, dword flags, long thresholdStart long thresholdEnd, ScopeEdgeAnalyseResult parameter[], dword parameterCount, ScopeAnalyseHandle handle) //Form 4

Perform an edge analysis for falling/rising edges of a specific frame or a complete node.

frame //Form 1,2,3: The CAN, LIN or FlexRay frame should be analyzed.
nodeName //Form 4: The node should be analyzed.
analyseRange: The start and end of the transition time measurement. See Class: scopeAnalyseRange.
flags:
- Bits:
  - 0: Define threshold level unit:
    - 0 = Threshold level in mV
    - 1 = Threshold level in %
  - 1-3: Select signal for transition time measurement (only valid for CAN)
    - Bit 1 = 1 Use CANhigh
    - Bit 2 = 1 Use CANLow
    - Bit 3 = 1 Use CANdiff
  - 4-5: Rising/falling edge selection
    - Bit 4 = 1 Use rising edges
    - Bit 5 = 1 Use falling edges
  - 6:
    - 0 = Use last occurrence for transition time measurement, where the voltage level is above or below the threshold level.
    - 1 = Use first occurrence for transition time measurement, where the voltage level is above or below the threshold level.
- All other bits are reserved and must be set to 0.
thresholdStart, thresholdEnd: The start/end threshold should be used. Can be defined as % or mV value. These values are used to measure the transition time of an edge.
parameters: The parameters should be measured. (See ScopeEdgeAnalyseResult)
parameterCount: The parameter count which are contained within the parameters array.
handle: A unique ID.

⌘I