Skip to main content

​
testWaitForScopeAnalyseBitSegments

Valid for: CANoe DE • CANoe4SW DE

​
Function Syntax

long testWaitForScopeAnalyseBitSegments(message aMessage, ScopeAnalyseBitSegment bitSegments[], dword noOfSegments, dword referenceVoltagePoint, dword flags, dword msgFieldStart, dword msgFieldEnd);

​
Description

Starts an analysis for the defined bit segments for each bit, which is within the defined range. The result of the analysis can be requested with the function testWaitScopeGetAnalysedBitSegments.

​
Parameters

  • aMessage: The message where the bits should be analyzed.
  • bitSegment: Array that defines the bit segments of a bit for the analysis (maximum number = 10). ScopeAnalyseBitSegment Selectors:
    • SegmentStart: Start of the bit segment in percent of the bit length (100% = nominal bit length)
    • SegmentEnd: End of the bit segment in percent of the bit length (100% = nominal bit length)
  • noOfSegments: Number of the bit segments used for the analysis.
  • referenceVoltagePoint: The reference voltage point within the bit in %.
  • flags:
    • 0: CAN high signal used for analysis
    • 1: CAN low signal used for analysis
    • 2: CAN diff signal used for analysis
    • 3: CAN common mode voltage (CMV) used for analysis
    All other bits are reserved and must be set to 0.
  • msgFieldStart, msgFieldEnd: Start and end field of the bit range.

​
Return Values

  • 0: Timeout
  • < 0: Error occurred. See EScopeCAPLFitDataReturnCode in ScopeBitAnalyse.cin
  • > 0: Number of analyzed bits.

​
Example

—